Woodworkers are now retrofitting spiral cutter
heads to their old planers, jointers for the following advantages.
* Smoother Finish with no tear-out. Each knife
sits at a slight angle and it produces a shear-cut. Spiral cutter head planes
board in a staggered cut which is much better than a single straight cut. The
combined shear and staggered cut eliminates tear-out and leaves a glossy
surface finish on even highly figured hardwood.
* Noise is hugely reduced as the spiral cutter
head allows a few knives to cut in a staggered way.
* More than 10 times the life use of high-speed
steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is
much harder than high-speed steel. Each insert has four edges.
* Easy to change. The knives are precision
ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable.
Loosen the screw, rotate 90° for a new edge, tighten the insert in minutes. It
cuts your production time by 30%.
* Dust extraction is easier. The spiral cutter
head produces thinner and shorter chips.
* Low cost to use. Spiral cutter heads produce a
smooth finish, reduce or eliminate sanding work, don't require sharpening, the
product will pay for itself in a very short time.
Ask Question About Product
Technical | |
Material of Cutterblock | Alloy Steel |
No. of Spirals | 4 |
No. of Carbide Inserts | 14PCS |
Carbide Insert Size | 15x15x2.5mm R150 30° |
Screw Size | T25 10#-32TPI |
Standard Kit | |
No. of Additional Knives | 5 |
No. of Additional Screws | 5 |
No. of Wrenches | 1 |
No. of Bearings | 2 |