Spiral Cutter head for Laguna 13" Moulder/Planer MPLAN1301-0130
* Better quality finish with no tear-out. All the inserts are angled along the helical in a staggered way and make shear-cut effects on even highly figured hardwood.
* Noise is hugely reduced as the spiral cutter head keeps constant contact with the board with only a few knives.
* All the cutters are made of solid tungsten carbide which is much harder and stayer sharp longer than high-speed steel blades. If one edge is chipped or dull, rotate it 90° for a new sharp edge. Each insert has four cutting edges and can be used four times.
* Easy to set up. The indexable carbide inserts are precision ground to a very tight tolerance and are interchangeable. Loosen the screws, rotate 90°, and tighten the inserts in minutes. The inserts can be precisely positioned by the taper hole style locking.
* Smaller carbide inserts remove shorter and thinner materials, which make dust extraction much more accessible.
* For the long term, spiral cutter heads are cheaper to use and can pay for themselves in a very short time.
Spiral Cutterhead Kit includes:
* High tensile strength alloy steel cutter block.
* 70 carbide inserts installed.
* 5 extra carbide inserts & 5 extra screws free as spare parts.
* 1 Wrench
Important to know
When installing this cutter head, you'll have to pass it through a narrow aperture in the machine housing. The cutter head won't fit through this aperture with the knives already attached. In such cases, it is recommended to remove one or two full sets of knives to facilitate installation. Once the cutter head is in place within the machine, install the knives and tighten them to a torque of 48 to 52 inch/pounds.
Ask Question About Product
Technical | |
Material of Cutterblock | Alloy Steel |
No. of Spirals | 5 |
No. of Carbide Inserts | 70 |
Carbide Insert Size | 15x15x2.5mm R150 30° |
Screw Size | T25 10#-32TPI |
Standard Kit | |
No. of Additional Knives | 5 |
No. of Additional Screws | 5 |
No. of Wrenches | 1 |
No. of Bearings | 2 |