Spiral Cutterhead for WEN 6552T 13-Inch Benchtop Thickness Planer with 40 knives
Woodworkers are now
retrofitting spiral cutterheads to their old planers, jointers for the
following advantages.
* Smoother Finish with
no tear-out. Each knife sits at a slight angle and produces shear-cut .
Spiral cutterhead planes board in a staggered way which is much better than
single straight cut. The combined shear and staggered cut eliminates tear-out
and leaves a glossy surface finish on even highly figured hardwood.
* Noise is dramatically reduced
as spiral cutterhead allows a few knives to cut in a staggered way.
* More than 10 times the
life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered
tungsten carbide which is much harder than high-speed steel. Each insert has
four edges.
* Easy to change. The
knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm are
interchangeable. Loosen the screw, rotate 90° for a new edge, tighten the insert
in minutes.
* Dust extraction is easier. Spiral cutterhead produces thinner and shorter chips.
* Low cost to use. Spiral cutterheads produce a smoother finish, reduce or eliminate sanding work, don't require sharpening, your product will pay for itself in a very short time.
Ask Question About Product
Technical | |
Material of Cutterblock | Alloy Steel |
No. of Spirals | 4 |
No. of Carbide Inserts | 40pcs |
Carbide Insert Size | 15x15x2.5mm R150 30° |
Screw Size | T25 10#-32TPI |
Standard Kit | |
No. of Additional Knives | 5 |
No. of Additional Screws | 5 |
No. of Wrenches | 1 |
No. of Bearings | 2 |