Upgrade your Rikon 6'' Jointer Model 20-100 by installing a Sheartak Spiral Cutterhead with 30 carbide inserts to enjoy a range of benefits:
1) Achieve a smoother finish with no tear-out: The slight angle of each knife on the spiral cutterhead produces a shear cut, while the staggered cut of the planes ensures a better finish than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves an exceptionally glossy surface finish even on highly figured hardwood.
2) Enjoy reduced noise: The spiral cutterhead allows a few knives to cut in a staggered way, which hugely reduces noise.
3) Get more than 10 times the lifespan of high-speed steel: The 15x15x2.5mm inserts are made of sintered tungsten carbide, which is much harder than high-speed steel. Each insert has four edges.
4) Experience easy changes: The knives are interchangeable and precision ground to a tolerance of +/-0.0004" or +/-0.01mm. Changing an insert is easy- loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes.
5) Improve dust extraction: The spiral cutterhead produces thinner and shorter chips, making dust extraction easier.
6) Enjoy a low cost to use: The spiral cutterhead produces a smooth finish, reduces or eliminates sanding work, and doesn't require sharpening. The product will pay for itself in a short time.
Standard Kit Includes:
* High tensile alloy steel cutter block
* 30 Carbide Inserts Installed
* Two Japan NSK sealed bearing preinstalled.
* 5 Additional Carbide Inserts
* 5 screws
* 1 Torx head T type key
Ask Question About Product
Technical | |
Material of Cutterblock | Alloy Steel |
No. of Spirals | 5 |
No. of Carbide Inserts | 30 |
Carbide Insert Size | 15x15x2.5mm R150 30° |
Screw Size | T25 10#-32TPI |
Standard Kit | |
No. of Additional Knives | 5 |
No. of Additional Screws | 5 |
No. of Wrenches | 1 |
No. of Bearings | 2 |