To reap several advantages, upgrade your Griggio FS 400 Planer Thicknesser with the Sheartak Spiral Cutterhead equipped with 96 Carbide Inserts, which offers the following benefits:
- The angled placement of each cutter and staggered cutting method combine to provide a smooth finish on any board while eliminating tear-out and ensuring quality cuts.
- Noise levels are significantly reduced as the cutters only remove material gradually along a short portion of the length.
- The 15x15x2.5mm inserts are constructed of sintered tungsten carbide, which is far more complex than high-speed steel and has four edges per insert.
- The carbide cutterheads are interchangeable, precisely ground to a high accuracy standard, and can be rotated 90 degrees for a new edge with just a few minutes of change-over time after loosening and tightening the inserts.
- The dust extraction process is more straightforward, with no chip clog during collection.
- The spiral cutterheads minimize sanding work by up to 75%, require no sharpening, and offer a low cost-to-use, ensuring a swift return on investment.
Spiral Cutterhead Kit includes:
* High tensile strength alloy steel cutter block.
* 96 carbide inserts installed.
* 5 extra carbide inserts.
* 5 extra screws.
* 1 Wrench
Ask Question About Product
Note: HTML is not translated!
| Technical | |
| Material of Cutterblock | Alloy Steel |
| No. of Spirals | 6 |
| No. of Carbide Inserts | 96 |
| Carbide Insert Size | 15x15x2.5mm R150 30° |
| Screw Size | T20 M6X1 |
| Standard Kit | |
| No. of Additional Knives | 5 |
| No. of Additional Screws | 5 |
| No. of Wrenches | 1 |
